Fostex VR800 owner manual Using a Program Change function, To enter a title

To enter a title:

•Turning the JOG dial will enter a character or number at the location of the flashing cursor. You can enter up to 16 characters, nine of which will appear on the display.

•To move the flashing cursor, press the HOLD/> key, the REWIND button, or the F FWD button. The F FWD button is the most convenient.

•You can enter the following characters and numbers:

VR800 Owner’s Manual (Handling Programs)

7. When you finish entering the title, press the EXECUTE/YES key.

Program 2 (PGM 02) and its title are set.

The display shows the ABS time base indication of the program.

<Important!>

•Whenever you create a new program by selecting the [New PGM ?] menu, a new program is created with an increment number. That is, if only one program exists, the next one will be named program 2.

If programs 1-5 already exist, the new program number will be 6.

•If there is insufficient recording space on the disk, you cannot create the new program. Each time you create a new program, the recordable area on the disk will decrease.

Using a Program Change function

If multiple programs exist on the disk, you need to select a program to record, play, or edit. This section

describes how to select a program.

Note: You cannot use the program change function if the VR800

is in SETUP mode.

1

	44.1kHz
SYNC OUT	DRIVE
CLK		SCSI
AUTO	A.PUNCH

	44.1kHz
DIGITAL

SURE ?
SYNC OUT	DRIVE
CLK	SCSI
AUTO	A.PUNCH

OPTICAL
ACCESS
OL
0
6
12
24
1 2 3 4 5 6 7 8	A SYNC

RECORD TRACK

1	2	3	4	5	6	7	8
		AUTO RTN		CLIPBOARD
	AUTO PUNCH					EXIT	EXECUTE
START	IN	OUT	END	IN	OUT	/ NO	/ YES
			PREVIEW			EJECT
HOLD/	STORE	EDIT	UNDO / REDO	DISP SEL	SETUP
PGM SEL
		AUTO RTN					JOG
	VARI PITCH	AUTO PLAY	LOCATE	TIME BASE SEL	SCRUB		SHUTTLE
SHIFT	P.EDIT		LOC MEM
RECORD		STOP	PLAY	REW	F FWD
AUTO		CLIPBOARD PLAY
PUNCH		LOCATE ABS	0

LOCATE REC END

3

2

2. Turn the JOG dial to select the desired program number (flashing).

Rotating the JOG dial counter-clockwise decreases the number. Rotating it clockwise increases the number.

If you turn the JOG dial clockwise all the way, [New PGM?] will be selected. Select [New PGM ?] to create a new program as mentioned in the previous section.

For example, you can select one of seven programs as follows:

PGM 01	PGM 02	PGM 03	PGM 04		PGM 05	PGM 06	PGM 07	New PGM
You can select up to PGM			You can select from PGM 03 up to
01 in this direction.				New PGM in this direction.

1. When the VR800 is stopped, press the STORE key while holding down the HOLD/> key.

[Select PGM] will appear on the display briefly, and then change to a flashing “01” ([#0001 of PGM 01) and [SURE?] flash. ([#0001] is the default name of PGM 01.)

3. Press the EXECUTE/YES key.

The ABS time base indication for the selected program appears. In this way, you can be sure to select a program before you start working.

33