Hitachi SJ300 Series manual 279

				SJ300 Inverter		C–11
	“C” Group Parameters		Default Setting		User
Func.
	Name	-FE (Europe)	-FU (U.S.)	-FR (Japan)	Setting
Code
C031	Terminal [11] active state	00	00	00
C032	Terminal [12] active state	00	00	00
C033	Terminal [13] active state	00	00	00
C034	Terminal [14] active state	00	00	00
C035	Terminal [15] active state	00	00	00
C036	Alarm relay active state	01	01	01
C040	Overload signal output mode	01	01	01
C041	Overload level setting	Rated current	Rated current	Rated current
		for each	for each	for each
		inverter	inverter	inverter			CAppendix
C042	Frequency arrival setting for accel.	0.00	0.00	0.00
C043	Arrival frequency setting for decel.	0.00	0.00	0.00
C044	PID deviation level setting	3.0	3.0	3.0
C045	Frequency arrival setting for	0.00	0.00	0.00
	acceleration (2)
C046	Frequency arrival setting for	0.00	0.00	0.00
	deceleration (2)
C055	Over-torque (forward-driving) level	100.	100.	100.
	setting
C056	Over-torque (reverse regenerating)	100.	100.	100.
	level setting
C057	Over-torque (reverse driving) level	100.	100.	100.
	setting
C058	Over-torque (forward regenerating)	100.	100.	100.
	level setting
C061	Electronic thermal warning level	80.	80.	80.
	setting
C062	Alarm code output	00	00	00
C063	Zero speed detection level	0.00	0.00	0.00
C070	Data command method	02	02	02
C071	Communication speed selection	04	04	04
C072	Node allocation	1.	1.	1.
C073	Communication data length selec-	7	7	7
	tion
C074	Communication parity selection	00	00	00
C075	Communication stop bit selection	1	1	1
C078	Communication wait time	0.	0.	0.
C081	[O] input span calibration	Factory set	Factory set	Factory set