Using the Front Panel Keypad
Inverter Mounting | and Installation |
•Function Key – This key is used to navigate through the lists of parameters and functions for setting and monitoring parameter values.
•Up/Down ( 1 , 2 ) Keys – Use these keys alternately to move up or down the lists of parameter and functions shown in the display, and increment/decrement values.
•Store ( STR ) Key – When the unit is in Program Mode and the operator has edited a parameter value, press the Store key to write the new value to the EEPROM. This param- eter is then displayed at powerup by default. If you want to change the powerup default, navigate to a new parameter value and press the Store key.
|
| HITACHI | POWER |
| ||
|
| ALARM |
| |||
| RUN |
| 5 0.0 | HZ |
|
|
| PRG |
| A |
|
| |
|
|
|
| V | kW |
|
|
|
|
|
|
| |
|
|
|
| % |
|
|
| RUN |
| STOP |
|
|
|
|
| RESET |
|
|
| |
|
|
| MIN |
| MAX |
|
| FUNC. | 1 | 2 | STR |
| |
|
|
|
|
|
| |
Function | Up/Down |
| Store | |||
key |
| keys |
| key |
Purpose of the keypad is to provide a way to change modes and parameters. The term function applies to both monitoring modes and parameters. These are all accessible through function codes that are primarily 3 or
Function | Type (Category) of Function | Mode to Access | PGM LED | |
Group | Indicator | |||
|
| |||
|
|
|
| |
|
|
|
| |
“D” | Monitoring functions | Monitor | or | |
|
|
|
| |
“F” | Main profile parameters | Program |
| |
|
|
|
| |
“A” | Standard functions | Program |
| |
|
|
|
| |
“B” | Fine tuning functions | Program |
| |
|
|
|
| |
“C” | Intelligent terminal functions | Program |
| |
|
|
|
| |
“H” | Motor constant functions | Program |
| |
|
|
|
| |
“P” | Expansion card functions | Program |
| |
|
|
|
| |
“U” | Monitor |
| ||
|
|
|
| |
“E” | Error codes | — | — | |
|
|
|
|
For example, function “A004” is the base frequency setting for the motor, typically 50 Hz or 60 Hz. To edit the parameter, the inverter must be in Program Mode (PGM LED will be ON). You use the front panel keys to first select the function code “A004.” After displaying the value for “A004,” use the Up/Down ( 1 or 2 ) keys to edit the value.
NOTE: The inverter
The inverter automatically switches into Monitor Mode when you access “D” Group functions. It switches into Program Mode when you access
MONITORPROGRAM
any other group, because they all have editable parameters. Error codes use the “E” Group, and appear automatically when a fault event occurs. Refer to “Monitoring Trip Events, History, & Conditions” on page
“D” Group
“A” Group
“B” Group
“C” Group
“H” Group
“P” Group
“U” Group
“F” Group