•If you select hosts and storage ports that are not contained in an existing zone alias, the new hosts and storage ports are added into the existing zone alias after the provisioning job finishes successfully.

1.Wait for all data to be loaded. All data has been loaded when you see the following messages:

•Host data Loaded.

•Loading volume data finished.

•Loading HSG data finished.

The Step 2 button is disabled until data has been loaded

2.Take one of the following actions:

•Select a host that is accessible.

•Add a host that is not currently connected to the network by clicking the button. See ”Adding a Host” on page 609.

Keep in mind the following:

•To create a provisioning job for multipathing, click the button above the Host pane, and then select the option for multipathing. When you select this option, you must select the same host for both paths. See ”Host Customize Dialog Box” on page 632 for more information.

•To automatically create a zone if a zone does not meet a preset criteria:

a.Click the button above the Zone pane.

b.Select the option Automatically create new zone if no existing zone containing HBA and storage system ports is detected.

c.Set the criteria. See ”Customize Zone Options Dialog Box” on page 633 for more information about setting the criteria.

d.Select a host and click Step 2.

•If the management server finds a zone that meets the criteria, it selects the zone in the Zone pane.

•If the management server does not find a zone that meets the criteria, it asks for a zone name. See ”Naming Conventions” on page 630 for more information about the naming requirements for a zone. After you enter a zone name, the new zone is displayed in the Zone pane, but it will not actually be created until the job runs.

•To configure zoning manually, click the button above the Zone pane, and then deselect the option, Automatically create new zone if no existing zone containing HBA and storage system ports is detected. In the zone pane, select a zone or create one manually.

3.Click the Step 2 button.

Information about the selected port, such as its WWN, is displayed below the Host pane. The volumes for that host are displayed in the Volume pane.

Adding a Host

The management server lets you add hosts that are not currently connected to the network. While you are creating a job, add the host.

HP Storage Essentials SRM 6.0 User Guide 609