HP XC System Software 3.2.1 manual ILO Settings for HP ProLiant DL360 G4 Nodes

5.Watch the screen carefully, and press the F9 key when prompted to access the ROM-Based Setup Utility (RBSU).

Table 4-6 iLO Settings for HP ProLiant DL360 G4 Nodes

Menu Name	Submenu Name	Option Name	Set to This Value
User		Add	Create a common iLO user name and password for
			every node in the hardware configuration. The
			password must have a minimum of 8 characters by
			default, but this value is configurable.
			The user Administrator is predefined by default,
			but you must create your own user name and
			password. For security purposes, HP recommends
			that you delete the Administrator user.
			You must use this user name and password to access
			the console port.
Network	DNS/DHCP	DHCP Enable	On
Settings	CLI	Serial CLI Speed	115200 (Press the F10 key to save the setting.)
		(bits/seconds)

Perform the following procedure from the RBSU for each node in the hardware configuration:

1.Make the following settings from the Main menu.

BIOS settings for HP ProLiant DL360 G4 nodes are listed in Table 4-7.

Table 4-7 BIOS Settings for HP ProLiant DL360 G4 Nodes

Menu Name	Option Name	Set to This Value
Standard Boot Order IPL		Set the following boot order on all nodes
		except the head node; CD-ROM does not
		have to be first in the list, but it must be
		listed before the hard disk:
		1.	CD-ROM
		2.	NIC1
		3.	Hard Disk
		On the head node, set the boot order so that
		the CD-ROM is listed before the hard disk.
Advanced Options	Processor Hyper_threading	Disable
System Options	Embedded Serial Port	COM2
	Virtual Serial Port	COM1
		Press the Esc key to return to the main
		menu.
BIOS Serial Console &	BIOS Serial Console Port	COM1
EMS
	BIOS Serial Console Baud Rate	115200
	EMS Console	Disable
	BIOS Interface Mode	Command-Line
		Press the Esc key to return to the main
		menu.

2.Press the Esc key to exit the RBSU. Press the F10 key to confirm your choice and restart the boot sequence.

3.Repeat this procedure for each HP ProLiant DL360 G4 node in the HP XC system.

4.5 Preparing the Hardware for CP3000 (Intel Xeon with EM64T) Systems 69