Table 4-37 RBSU Settings for HP ProLiant DL585 G2 Nodes (continued)
Menu Name | Option Name | Set to This Value | |
Standard Boot Order (IPL) |
| Set the following boot order on all nodes except | |
|
| the head node; the | |
|
| the hard drive: | |
|
| • | IPL:1 |
|
| • | IPL:2 Floppy Drive (A:) |
|
| • | IPL:3 USB Drive Key (C:) |
|
| • | IPL:4 PCI Embedded HP NC373i |
|
|
| Multifunction Gigabit Adapter |
|
| • | IPL:5 Hard Drive C: |
|
| Set the following boot order on the head node: | |
|
| • | IPL:1 |
|
| • | IPL:2 Floppy Drive (A:) |
|
| • | IPL:3 USB Drive Key (C:) |
|
| • | IPL:4 Hard Drive C: |
BIOS Serial Console and | BIOS Serial Console Port | COM1 | |
EMS |
|
|
|
| BIOS Serial Console Baud | 115200 | |
| Rate |
|
|
| EMS Console | Disabled | |
| BIOS Interface Mode | Command Line | |
Advanced | Linux x86_64 HPET Option | Enabled | |
2.Press the Esc key to exit the RBSU. Press the F10 key to confirm your choice and restart the boot sequence.
3.Repeat this procedure for each node HP ProLiant DL585 G2 node in the hardware configuration.
Configuring Smart Arrays
On such hardware models as the HP ProLiant DL585 and DL585 G2 with smart array cards, you must add the disks to the smart array before attempting to image the node.
To do so, watch the screen carefully during the
Specific instructions are outside the scope of the HP XC documentation. See the documentation that came with the HP ProLiant server for more information.
4.7.9 Preparing HP ProLiant DL585 G5 Nodes
On HP ProLiant DL585 G5 servers, use the following tools to configure the appropriate settings for an HP XC system:
•Integrated Lights Out (iLO) Setup Utility
•
HP ProLiant DL585 G5 servers use the iLO utility; thus, they need certain settings that you cannot make until the iLO has an IP address. The HP XC System Software Installation Guide provides instructions for using a browser to connect to the iLO to enable telnet access.
