Intel manual EPAxCON Address Table C-4 = 0-1 8XC196MH, = 0-3 8XC196MC x = 0-5 8XC196MD

		REGISTERS
		EPAx_CON
EPAx_CON (Continued)	Address:	Table C-4
x = 0–1 (8XC196MH)	Reset State:

x = 0–3 (8XC196MC) x = 0–5 (8XC196MD)

The EPA control (EPAx_CON) registers control the functions of their assigned capture/compare channels.

x = 0, 2, 4

x = 1, 3, 5

7							0
TB	CE	M1	M0	RE	WGR	ROT	ON/RT
7							0
TB	CE	M1	M0	RE	AD	ROT	ON/RT

Bit	Bit		Function
Number	Mnemonic
3	RE	Re-enable
		Re-enable applies to the compare mode only. It allows a compare event
		to continue to execute each time the event-time register (EPAx_TIME)
		matches the reference timer rather than only upon the first time match.
		0 = compare function is disabled after a single event
		1 = compare function always enabled
2	WGR	Waveform Generator Reload; A/D Conversion
	AD	The function of this bit depends on the EPA channel.
		For EPA capture/compare channels 0, 2, 4:
		The WGR bit allows you to use the EPA activities to cause the reload
		of new values in the waveform generator.
		0	= no action
		1	= enables waveform generator reload
		For EPA capture/compare channels 1, 3, 5:
		The AD bit allows you to use the EPA activities to start an A/D
		conversion that has been previously set up in the A/D control
		registers.
		0	= causes no A/D action
		1	= starts an A/D conversion on an output compare
1	ROT	Reset Opposite Timer
		Controls different functions for capture and compare modes.
		In Capture Mode:
		0	= causes no action
		1	= resets the opposite timer
		In Compare Mode:
		Selects the timer that is to be reset if the RT bit is set.
		0	= selects the reference timer for possible reset
		1	= selects the opposite timer for possible reset
		The TB bit (bit 7) selects which is the reference timer and which is the
		opposite timer.

C-19