Kyocera 3035, 5035, 4035 manual Troubleshooting, Message Procedure Reference

Section 9 TROUBLESHOOTING

Message	Procedure	Reference
		page
“Call service.”	Open and close the front cover. If the same message appears again, make a note of	——
	the “C” and the number appearing with it, turn the power switch OFF (O), unplug the
	power cord from the outlet, and contact your service representative or authorized
	service center.
“Time for maintenance.”	Periodic maintenance is necessary to keep your copier in good condition.	——
	Contact your service representative or an authorized service center as soon as
	possible.
“Close Document processor cover.”	The Document Processor original cover of the optional document processor is open.	——
	Close the cover securely.
“Memory full.”	The copier memory is full. Either print out or clear all scanned data. It is not possible	——
	to copy or scan another original until one of these two operations is performed.
	The copier memory size and the capacity for scanning originals are shown below.
	Number of originals that can be scanned*
	Standard memory (64MB): approximately 322 pages
	When the optional Hard Disk is installed (20GB): approximately 70,000 pages**
	* When using our standard original (A4 original, 6% text)
	** The maximum number of originals that can be scanned at one time is 999
	(11" x 8 1/2" [A4]).
“Paper misfeed.”	If paper is misfed, the copier will stop and the location of the misfeed will appear on	9-4
“Paper misfeed. Careful for Drum.”	the message display. Remove the misfed paper with the power switch turned ON ( )
	by following the appropriate procedure. If “Careful for Drum.” is displayed, be sure not
	to touch the drum area that is located inside the machine when removing the
	jammed paper.
“Duplex tray inoperable, call service.”	The duplex unit is out of order and duplex copying is not possible.	——
[“Duplex unit is out of order. Call	Contact your service representative immediately.
service.”]
“Clean the slit glass for original fed from	The slit glass is dirty. This may result in black lines or other blemishes appearing on	10-1
DP.” [“Clean the slit glass for original	copies when you use the optional Document Processor, so you should perform the
fed.”]	cleaning operation on the slit glass.
“Attach Finisher.”	Connect the optional Document Finisher securely to the copier.	——
“Finisher is out of order. Detach	The optional Document Finisher is out of order and cannot be used for the moment.	——
Finisher.”	Contact your service representative or an authorized service center as soon as
	possible.
“Paper capacity exceeded. Remove	The maximum number of sheets that can be stored on the optional Document	——
paper from Finisher.”	Finisher has been exceeded. Remove the copies from the Document Finisher.
“Remove paper form inner tray of	Paper has been misfed inside the optional Document Finisher. See the Document
Finisher.”	Finisher’s Operation Guide and remove the paper.

9-2