Section 8 OPTIONAL EQUIPMENT

IMPORTANT!

The position of the holes on each page may differ very slightly due to the fact that holes are punched in one sheet at a time.

5Set the originals to be copied.

6Press the [Start] key. Scanning of the originals will start. The number of scanned originals will be displayed.

NOTE

Repeat this operation for all originals when using the platen. After all the originals have been scanned, touch the “Scanning finished” key.

7Copying will begin and the copies will be automatically punched and ejected face down onto the tray.

8Remove all of the finished copies from the tray.

(5) Document Finisher

The Document Finisher stores a large quantity copies, and sorts multiple sets by shifting the position that each one is ejected. It is also possible to use the Document Finisher to staple the copy sets or punch holes in them for filling purposes.

For detailed information on the sort mode, refer to the Operation Guide for the Document Finisher. For more information on the corresponding procedures, refer to “(4) Document Finisher” on page 8-5 of this guide.

(6) Document Finisher

The Document Finisher stores a large quantity copies, and sorts multiple sets (Sort: ON) or groups copies made from multiple originals, with all the copies produced from an individual original grouped together in one set (Sort: OFF). It is also possible to use the Document Finisher to staple sorted copy sets.

For detailed information on the sort mode, refer to the Operation Guide for the Document Finisher. For more information on the corresponding procedures, refer to “(4) Document Finisher” on page 8-5 of this guide.

*Stapling will be accomplished as shown in the illustration (at the top and from the front of the copies).

A A

* Stacking mode

If the number of copies to be made in the Non-sort mode is set to a number greater than the acceptable limit (250 sheets), the finished copies will be ejected onto the Sort tray.

(7) Built-in Finisher

The finisher stores a large quantity of copies. It can also sorts multiple copies into sets by shifting the eject position. Paginated copies can be stapled, too.

1

2

1Sort tray

2 Finisher tray

8-9

Page 255
Image 255
Kyocera 5035, 4035, 3035 manual Built-in Finisher, Stacking mode