Kyocera 5035, 4035, 3035 manual Auto clear function, Automatic drawercassette switching function

Section 2 NAMES OF PARTS

●Initial mode (at the end of warm-up or when the [Reset] key is pressed)

In the default settings prepared at the factory, paper of the same size as the original is selected automatically and the copy magnification ratio is set to “100%” [1:1] (under the auto paper selection mode), the number of copies to be made is set to “1” and the image quality is set to the text+photo mode.

NOTES

•The default settings for the initial mode can be changed using the corresponding “copy default settings” procedure.

•It is possible for you to change the default setting for the copy exposure in the initial mode from the “manual exposure mode” to the “auto exposure mode”. (See “Exposure mode” on page 7-63.)

●Auto clear function

Once a designated amount of time has passed after copying stops (between 10 and 270 seconds), the auto clear function will automatically engage and the copier will return to the same settings as those after warm up (initial mode settings). (However, the copy exposure mode and the image quality mode will not change.) Copies can continually be made using the same settings (copy mode, number of copies and exposure mode) if the next batch of copying is started before the auto clear function engages.

●Automatic drawer[cassette] switching function

If two drawers[cassettes] contain the same size of paper and the paper in one drawer[cassette] runs out during copying, the automatic drawer[cassette] switching function will switch to paper feed from the other drawer[cassette] that still contains paper.

NOTES

•The automatic drawer[cassette] switching function can be turned OFF. (See “Auto drawer[cassette] switching ON/OFF” on page 7-42.)

•Paper must be loaded in the same orientation in both drawers[cassettes].

•Only drawers[cassettes] that are loaded with the same type of paper can be used with the automatic drawer[cassette] switching function.

2-4