Kyocera 5035, 4035, 3035 manual Preparations, Loading paper into the drawercassette

Section 3 PREPARATIONS

(2) Loading paper into the drawer[cassette]

Up to 500 sheets of standard paper (75 or 80 g/m2/standard paper as specified by our company) or colored paper can be loaded into the each drawer[cassette].

The each drawer[cassette] can be set to hold paper of any desired size from 5 1/2" x 8 1/2", 8 1/2" x 11", 11" x 8 1/2", 8 1/2" x 13", 8 1/2" x 14", 11" x 17", A5R, B5R, B5, A4R, A4, B4, A3, Folio, 8K and 16K.

IMPORTANT!

Set the type of paper (standard paper, recycled paper, etc.) to be loaded in the drawer[cassette] in “Paper type (drawer[cassette] No.1 - No. 4)” on page 7-44.

1Pull the drawer[cassette] out toward you as far as it will go.

*Do not pull more than one drawer[cassette] out at a time.

2Hold the width adjustment lever and move it to align the width guide with the required paper width.

Paper sizes are marked inside the drawer[cassette].

3Hold the length adjustment plate and move it to align with the required paper length.

4Set the paper flush against the left-hand wall of the drawer[cassette].

IMPORTANT!

•Make sure that there are no folds, etc., in the paper when it is set in a drawer[cassette]. Such paper may be the cause of paper jams.

•There is a sticker (1 in the illustration) indicating paper capacity attached to the inside of the drawer[cassette]. Do not load paper above this limit.

•When you are loading paper into a drawer[cassette], make sure that the side facing upward when the package is opened is the side that is facing upward in the drawer[cassette].

•Adjust the length adjustment plate and the width guide BEFORE loading paper into a drawer[cassette]. Failure to do so may result in skewed paper feed or a paper jam.

•Make sure that the paper is set securely against the length adjustment plate and the width guide. If there is a gap between the paper and the adjustment plate or the width guide, readjust the plate and the guide to fit the paper snugly.

1

3-2