Kyocera 3035, 5035 Default settings, Machine default settings, Folio 11 x 2 x 11 x 8 1/2, 2 x 16K

Section 7 COPIER MANAGEMENT FUNCTIONS

2. Default settings

The state that the copier enters at the end of warm-up or when the [Reset] key is pressed is called the “initial mode”. The modes, functions and other settings that are automatically pre-set for the initial mode are called “default settings”. These default settings are separated into two categories: “Copy defaults” and “Machine defaults” and can be changed as desired to suit your copying needs.

(1) Machine default settings

The following table indicates the machine default settings available in this copier. Change any or all of the settings as desired in order to make the most effective use of your copier.

Default setting			Description		Available			Factory	Reference
						settings		setting	page
Auto drawer[cassette]	If the paper in one drawer[cassette] runs out during			On / Off			On		7-42
switching ON/OFF	copying, the automatic drawer[cassette] switching
	function will switch paper feed from the empty
	drawer[cassette] to another drawer[cassette] that
	contains the same size of paper in the same orientation
	for uninterrupted copying. To enable this function, it is
	necessary to turn the related setting “On”.
	In order to prevent a drawer[cassette] that holds a different			All types of paper /			All types of
	type of paper from being switched to when the automatic			Feed same paper			paper
	drawer[cassette] switching function is turned ON, it is			type
	necessary to select “Feed same paper type” as well.
Paper size	Sets the size of paper that is loaded in			Auto Detection /			Auto Detection		7-43
(drawer[cassette] No.1 –	drawers[cassettes] No.1 through No.4.			Standard sizes
No.4)	If you want the size to be detected automatically, select
	“Auto Detection” (Automatic size detection). If you want
	to manually set the size of paper, select “Standard
	sizes”.
	<If you select “Auto Detection”>			Inch			Inch
	You can also select the desired unit of measurement:			Centimeter			specification:
	“Inch” or “Centimeter”.						Inch
							Metric
							specification:
							Centimeter
	<If you select “Standard sizes”>			A3			– – –
	You can then select the paper size.			A4
				A4R
	* The setting for drawer[cassette] No.3 and No.4 will only			A5R
		be available when the optional Paper Feeder is		B4
		installed on your copier.		B5
				B5R
				Folio
				11 x 17
				8 1/2 x 14
				11 x 8 1/2
				8 1/2 x 11
				5 1/2 x 8 1/2
				8 1/2 x 13
				8K
				16K

7-38