Lexmark MS810DE, 40G0350, 40G0110, 40G0150, 40G0440, 40G0410, 40G0210 manual Cleaning the printer parts

Maintaining the printer 266

3Squeeze both sides of the empty staple case with your fingers, and then remove the staple case from the cartridge.

1

1

4Insert the front side of the new staple case into the staple cartridge, and then push the rear side into the cartridge.

2

1

5Push the staple cartridge into the finisher until it clicks into place.

6Close the stapler door.

Cleaning the printer parts

Cleaning the printer

Note: You may need to perform this task after every few months.

Warning—Potential Damage: Damage to the printer caused by improper handling is not covered by the printer warranty.

1Make sure that the printer is turned off and unplugged from the electrical outlet.

CAUTION—SHOCK HAZARD: To avoid the risk of electrical shock when cleaning the exterior of the printer, unplug the power cord from the electrical outlet and disconnect all cables from the printer before proceeding.

2Remove paper from the standard bin and multipurpose feeder.

3Remove any dust, lint, and pieces of paper around the printer using a soft brush or vacuum.