Lexmark 40G0150, 40G0350 Maintenance kit very low, x estimated pages remain 80.xy, Memory full

Troubleshooting 301

Maintenance kit very low, [x] estimated pages remain [80.xy]

You may need to replace the maintenance kit very soon. For more information, contact customer support at http://support.lexmark.com or your service representative.

If necessary, select Continue on the printer control panel to clear the message and continue printing. For

non‑touch‑screen printer models, press to confirm.

Memory full [38]

Try one or more of the following:

•From the printer control panel, select Cancel job to clear the message. For non‑touch‑screen printer models, press

to confirm.

•Install additional printer memory.

Network [x] software error [54]

Try one or more of the following:

•From the printer control panel, select Continue to continue printing. For non‑touch‑screen printer models, press

to confirm.

•Turn off the printer, wait for about 10 seconds, and then turn the printer back on.

•Update the network firmware in the printer or print server. For more information, contact customer support.

Non‑Lexmark [supply type], see User’s Guide [33.xy]

Note: The supply type can be toner cartridge or imaging unit.

The printer has detected a non‑Lexmark supply or part installed in the printer.

Your Lexmark printer is designed to function best with genuine Lexmark supplies and parts. Use of third-party supplies or parts may affect the performance, reliability, or life of the printer and its imaging components.

All life indicators are designed to function with Lexmark supplies and parts and may deliver unpredictable results if third-party supplies or parts are used. Imaging component usage beyond the intended life may damage your Lexmark printer or associated components.

Warning—Potential Damage: Use of third-party supplies or parts can affect warranty coverage. Damage caused by the use of third-party supplies or parts may not be covered by the warranty.

To accept any and all of these risks and to proceed with the use of non-genuine supplies or parts in your printer, press

and hold and the # button on the printer control panel simultaneously for 15 seconds.

For non‑touch‑screen printer models, press and on the printer control panel simultaneously for 15 seconds to clear the message and continue printing.

If you do not wish to accept these risks, then remove the third-party supply or part from your printer, and then install a genuine Lexmark supply or part.

Note: For a list of supported supplies, see the “Ordering supplies” section of the User's Guide or visit www.lexmark.com.