![](/images/new-backgrounds/1211940/211940199x1.webp)
Return to Section TOC
Return to Master TOC
F-30 TROUBLESHOOTING & REPAIRF-30
OIL PRESSURE - TEMPERATURE SWITCH TEST (CONTINUED)
FIGURE F.10 - SWITCH
Return to Section TOC
Return to Master TOC
OIL SWITCH / SENDER
G WK
TEMP SW. / SENDER
S25162
1/4" SPADETERMINAL | GND | ||
|
|
| |
| W | G |
|
|
|
| + |
|
|
| .19 |
| 3/16" SPADETERMINAL |
WK TERMINAL TO GROUND TO CASE AT 6
Oil Pressure Switch/Sender Resistance Test.
Return to Section TOC
to Section TOC
Return to Master TOC
Return to Master TOC
PROCEDURE
1. With the engine not running locate the Oil Pressure Switch/Sender.
2. Remove the two leads from the switch.
3. Using the ohmmeter check the resistance from terminal WK to case ground. This is a normal- ly closed switch and should be at a very low resistance. (Less than 1 ohm)
4. Using the ohmmeter check the resistance from terminal G to case ground. This resistance should be approximately 10 ohms with zero PSI oil pressure.
5. With the engine running and an oil pressure of 6 PSI or greater the resistance from terminal WK to case ground should be very high. (open). While the engine is running if the oil pressure should drop below 6 PSI the switch would close and shut off the engine.
6. With the engine running the resistance from terminal G to case ground should be as fol- lows.
• 0 PSI equals approximately 10 ohms
• 40 PSI equals approximately 105 ohms
• 80 PSI equals approximately 187 ohms
8. Replace the two leads previously removed.
Return