![](/images/new-backgrounds/1211940/211940233x1.webp)
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
| TROUBLESHOOTING & REPAIR | |||
| DC EXCITER ARMATURE & FIELD COILS |
| ||
| REMOVAL AND REPLACEMENT PROCEDURE |
| ||
Field Coils Removal Procedure | Reassembly: |
| ||
1. | Perform the DC Exciter Armature Removal | 7. Assemble the new coils to their respective | ||
2. | Procedure. |
| pole pieces. |
|
Using the 3/8” wrench, remove the leads from | 8. Assemble the coil and pole pieces to the | |||
| the brush holder. | Note lead placement for | exciter frame with four bolts. |
|
3. | reassembly. |
| 9. Make the necessary lead connections to the | |
Using the 1/2” wrench, remove the four bolts | idler board and 115VDC receptacle. | Wrap | ||
| (two on each side) holding the pole pieces to | the slices with tape. |
| |
4. | the exciter frame. | See Figure F.15. | 10. Assemble the armature and brushes. | |
Label and remove the tape and splices from | See the DC Exciter Armature Removal | |||
| the black and red leads that go to the idler | Procedure. |
| |
| board and 115VDC receptacle. See the |
|
| |
5. | Wiring Diagram. |
|
|
|
Carefully slide the coils and pole pieces from |
|
| ||
6. | the exciter frame. |
|
|
|
Remove the coils from the pole pieces. |
|
|