Lucent Technologies Release 3 Version 8 manual Migrate Administration Data

Upgrading CMS to the High Availability Option	CentreVu CMS R3V8 High Availability
	Connectivity, Upgrade and Administration
Migrating Administration Data Back Onto the Original Server	3-70

6.The Status: field reports the progress of the migration. When the migration ends, Status: indicates the success or failure of the run.

7.When the migration is finished, remove the incremental tape from the drive and insert the original full maintenance backup (“Performing a Full Maintenance Backup” on Page 3-11 ) and repeat steps 2 through 6.

8.To print out the customer migration log, enter: lp /cms/migrate/r3mig.log

For help interpreting the log and its messages, U.S. customers can telephone the Lucent National Customer Care Center at

1-800-242-2121; international customers should contact their Lucent distributors or customer representatives.

The services migration log is found in /cms/maint/r3mig/mig.log.

Note:

Printer administration must be done on the new HA server before this step can be performed.

Migrating Administration Data Back Onto the Original Server

After the original server is upgraded to the same CMS version and base load as the new HA server, the original administration data, which was copied to tape in the first maintenance backup (“Performing a Maintenance Backup (Administration Data Only)” on Page 3-12) is migrated back onto the system. After this procedure is performed, the two servers should share identical sets of administration data.

.

! WARNING:

Migrate the

Administration

Data

Attempting to migrate CMS data more than once may cause catastrophic errors from which recovery is difficult. Before a re-migration of data can be performed, CMS must be turned off and a second setup of the CMS software must be performed.

Insert the initial maintenance backup tape back into the tape drive of the original server.

1.Log in as a CMS user.

The CMS main menu is displayed.

2.Select System Setup - CMS State from the CMS main menu and select the Single User Mode option.