
3-60 Administrator’s Handbook
66. | IKE: phase 1 auth failure sg [IP Address] | profile [Name], sg [IP Address] code [code] | ||
67. | IKE: phase 1 resend timeout sg [IP Address] | profile [Name], sg [IP Address] | ||
68. | IKE: phase 1 complete sg [IP Address] | profile [Name], sg [IP Address] | ||
69. | IKE: phase 2 hash failure sg [IP Address] | profile [Name] sg [IP Address] | ||
70. | IKE: no matching ph2 proposal sg [IP Address] profile [Name] sg [IP Address] | |||
71. | IKE: ph2 resend timeout sg [IP Address] |
| profile [Name], sg [IP Address] | |
72. | IKE: phase 2 complete sg [IP Address] | profile [Name], sg [IP Address] | ||
73. | IPSEC: Dead Peer Detected sg [IP Address] | profile [Name], sg [IP Address] |
74.L2TP: tunnel up, rem: [IP Address], via: [IP Address] id: [ID]
75.L2TP: tunnel down, rem: [IP Address], tunnel id: [ID]
76.L2TP: peer failed to authenticate, tunnel id: [ID]
77.L2TP: no matching profile for rcvd hostname, id: [ID]
78.L2TP: session up, session id: [SessionID], tunnel id: [ID]
79.L2TP: session down, session id: [SessionID]
80.L2TP: tunnel result code = [Result], error code = [Error]
81.L2TP: session result code = [Result], error code = [Error]
82.SCHED: Next retry in [Num.] seconds profile [Name]
Procedure for Default Installation for ICSA firewall certification of Small/Medium Business Category Module (ADSL Routers)
Note: The following installation procedure outlines steps needed to enable required features to comply with ICSA firewall certification. For more information please go to the following URLs:
http://www.icsalabs.com/icsa/docs/html/communities/firewalls/pdf/4.1/baseline.pdf
http://www.icsalabs.com/icsa/docs/html/communities/firewalls/pdf/4.1/smb.pdf
Install via the Console menu
1.Access the Router through the serial interface (if available) or telnet to the product from the private (LAN) side. DHCP server is enabled on LAN by default. See “Connecting through a Telnet Session” on page
Set up a Connection Profile to configure WAN connectivity: (Follow the Easy Setup instructions in the Quickstart Guide, or create a new Connection Profile. See “Creating a New Connection Profile” on page
2.Go to Easy Setup…
3.Set Data Circuit VPI
4.Set Data Circuit VCI
5.Select NEXT SCREEN