![](/images/new-backgrounds/1213653/21365321x1.webp)
Introduction
Chapter 1
Introduction
This Administrator’s Handbook covers the advanced features of the Motorola Netopia® ENT
Your Motorola Netopia® equipment offers advanced configuration features accessed through the Main Menu of the Telnet configuration screen. This Administrator’s Handbook documents the advanced features, including advanced testing, security, monitoring, and configuration. This Administrator’s Handbook should be used as a companion to the Quickstart Guide and the Getting Started Guide. You should read the Quickstart Guide and the Getting Started Guide before reading this Administrator’s Handbook.
What’s New in 8.7.4
New in Motorola Netopia® Embedded Software Version 8.7.4 are the following features:
•Specify Source Address of Outbound Router Traffic. See “Enhanced Dead Peer Detection” on page
•Ability to support multiple networks over the same IPSec tunnel. See “Multiple Network IPsec” on page
•Backup timer can now be set in seconds instead of minutes. Minimum failure setting has been reduced to 10 seconds. See Chapter 8, “Line Backup.”
•
•VLAN enhancements. See “VLAN Configuration” on page
•IP multicast to layer 2 unicast mapping. See “IGMP (Internet Group Management Protocol)” on page
Corresponding commands have been added to the Command Line Interface (CLI). In addition:
•DHCP Generic Options support.
•DHCP filtersets support.
•Support for router generated packets with their source address outside the local member range for IPSec force all tunnels.
See the Command Line Interface Commands Reference available on the Motorola Netopia® website.