Windows Setup and Operation 3-41

[Team #1: Adaptive Fault Tolerance Mode] is added to Network Component Tree.

3.Select [Stratus emb-82559 10/100 Enet Adapter] from Network Component Tree. The pop-up menu appears. Select [Team #1: Adaptive Fault Tolerance Mode] from [Add to Team], and add the adapters.

You will see the warning message when you add the team. You can ignore this warning message by clicking [OK]. This warning message is to inform you that only one adapter is added to the team.

4.Select [Stratus emb-82559 10/100 Enet Adapter #2] from Network Component Tree in the same manner as for 4. The pop-up menu appears. Select [Team #1: Adaptive Fault Tolerance Mode] from [Add to Team], and add the adapters.

IMPORTANT: Do not set [Preferred Primary] or [Preferred Secondary] to each adapter.

5.Make settings of dual configuration for "Stratus emb-82544GC Copper Gigabit Adapter"

(1000Base) as well.

Perform 3 to 5 in the same manner, replacing [Stratus emb-82559 10/100 Enet Adapter] with [Stratus emb-82544GC Copper Gigabit Adapter].

In 3, you can also select [Load Balancing]. In this case, [Team #X: Adaptive Load Balancing Mode] will be added.

When the option boards are used, perform 3 to 5 in the same manner, replacing [Stratus emb-82559 10/100 Enet Adapter] with the following.

N8804-001P1: [Stratus AA-U51500 10/100 Enet Adapter]

N8104-84: [Stratus AA-U57000 Fiber Gigabit Adapter]

N8104-103: [NEC 8490XT Copper Gigabit Adapter]