5-76 Installing and Using Utilities

Connect from the Management PC Linked through LAN

On the management PC that is linked through LAN, perform the steps below:

1.Start the management PC where NEC MWA is installed. From the Start menu, select [Program] → [NEC MWA] → [MWA].

When NEC MWA starts, the initial screen “Remote Control Manager” will appear.

2.Insert a formatted 1.44MB floppy disk into the drive.

3.From NEC MWA’s [File] menu, select [Configuration] command to open [Configuration] dialog box.

4.Select [New] to display the [Select a model] dialog box.

5.Check [Write to FD] and select an applicable model to open [Configuration for ft Server] dialog box.

Ex) The model name is printed on the front cover like “NEC Express5800/320Lc,” or “NEC Express5800/320Lc-R.”

6.On the [Configuration for ft Server] dialog box, specify/register configuration information including the names of computers to be managed, and then write the information to FD as the following filename:

<Filename>

CSL_LESS.CFG

The setting items of the server are as follows: Computer Name (The managed server name. Arbitrary) IP address

Subnet mask Default gateway

Primary contact (Management PC’s IP address)

7.Right-click the server name to open the pop-up menu, from which select [Property] command to open [Property] dialog box.

8.When the [Property] dialog box appears, specify the items as follows:

<[ID] page>

 

Connection mode:

LAN

<[Alert notification] page>

Uncheck [Use Default Settings] and check [Reset] of [Activate].