4-40 System Configuration

Pins for protecting/clearing the passwords

Place the clip on the two pins to clear the passwords.

Remove the clip from these pins to protect the passwords (factory-set). Pins for protecting/clearing the CMOS data

Place the clip on the two pins to clear the CMOS data.

Remove the clip from these pins to protect the CMOS data (factory-set). The following describe the clearing procedure.

WARNING

Observe the following instructions to use the server safely. There are risks of death or serious personal injury. See PRECAUTIONS FOR SAFETY in Chapter 1.

Do not disassemble, repair, or alter the server.

How to Clear CMOS

1.Power off the NEC Express5800/ft series and unplug the both power cords.

2.Remove the both PCI modules (#1 and #2) from the NEC Express5800/ft series (see “Removing PCI Module” on page 8-29).

3.Open the top cover of the PCI Module #1.

4.Make setting of jumper switch for clearing CMOS.

Remove the clips from the jumper pins 11-12 and place them on the jumper pins 1-2 on the PCI Module #1.

5.Mount only the PCI Module #1 to the NEC Express5800/ft series (see “Installing PCI Module” on page 8-31).

6.Plug the both power cords and when the POWER Switch LED turns on, press it to power on the server.

7.When the following message appears after startup, press [CONTINUE].