SCSI Bus Settings
If you put the cursor on "SCSI Bus Settings" with keyboard cursors (↓ and ↑) in the "Configuration Settings" menu and press Enter, the screen for setting the information on the SCSI bus of the host adapter appears.
The table below shows the parameters of the setting items and their factory settings.
IMPORTANT: The settings can be made for each SCSI bus.
Submenu item | Parameter |
| Description | |
| SCSI Bus0 | SCSI Bus1 |
|
|
SCSI Bus SCSI ID | 0, 1, 2, 3, 4, 5, 6, | 0, 1, 2, 3, 4, 5, 6, | Select the SCSI ID given to SCSI | |
| [7], 8, 9, 10, 11, | [7], 8, 9, 10, 11, | bus. | |
| 12, 13, 14, 15 | 12, 13, 14, 15 |
|
|
SCSI Bus Reset | [Enabled] | [Enabled] | Make the reset valid or invalid in | |
| Disabled | Disabled | SCSI buses. | |
SCSI Bus Reset | 0, 1, 2, 3, 4, [5], | 0, 1, 2, 3, 4, [5], | Leave this item as | |
Delay | 6, 7, 8, 9, 10, 11, | 6, 7, 8, 9, 10, 11, |
|
|
| 12, 13, 14, 15 | 12, 13, 14, 15 |
|
|
SCSI Bus | Auto | [Auto] | Set the termination resistance of | |
Termination | High only | High only | SCSI bus. | |
| Disabled | Disabled |
|
|
| [Enabled] | Enabled |
|
|
|
|
| [ ]: |
|
Autoconfigure SCSI Device
If you put the cursor on "Autoconfigure SCSI Device" with keyboard cursors (↓ and ↑) in the "Configuration Settings" menu and press Enter, the screen for setting the information on the device connected to the host adapter appears.
The parameters of the setting items and their factory settings are the same as those shown in the table for "SCSI Device Settings."
IMPORTANT:
The settings can be made for each SCSI bus and SCSI ID. Check the SCSI ID of the target device before changing the settings.
The factory settings are the same for both SCSI bus 0 and SCSI bus 1.
The following items can be changed by setting "Adapter Configuration" in "Host Adapter Settings" to "Manual."
–Enable Device
–Enable LUNs
–Negotiate Wide
–Negotiate Sync
–Tagged Queuing
–Sync Offset
–Sync Period
–Exec Throttle