If you select "Configuration Settings" from the "Fast!UTIL Options" menu, the screen for setting the configuration appears.
Configuration Settings
Host Adapter Settings
SCSI Device Settings
SCSI Bus Settings
Autoconfigure SCSI Device
Selectable Boot Settings
Restore Default Adapter Settings
Raw Nvram Data
Host Adapter Settings
If you put the cursor on "Host Adapter Settings" with keyboard cursors (↓ and ↑) in the "Configuration Settings" menu and press Enter, the screen for setting the information on the host adapter appears.
The table below shows the parameters of the setting items and their factory settings.
Submenu item | Parameter | Description | |
BIOS Address | - | View only | |
BIOS Revision | - | View only | |
Adapter Serial Number | - | View only | |
Interrupt level | - | View only | |
Host Adapter BIOS | [Enabled] | Specify whether the BIOS extension of the host | |
| Disabled | adapter is enabled or disabled. | |
PCI Bus DMA Burst | [Enabled] | Specify whether the DMA burst transfer on the PCI | |
| Disabled | bus is enabled or disabled. | |
CDROM Boot | Enabled | Specify whether the start from | |
| [Disabled] | disabled. | |
Adapter Configuration | [Auto] | Specify whether the adapter configuration is set | |
| Manual | automatically by BIOS, manually, or safely. | |
| Safe |
|
|
Drivers Load RISC | [Enabled] | Specify whether the load of RISC codes is enabled or | |
| Disabled | disabled. | |
>4GByte Addressing | Enabled | Specify whether hard disks of 4 GB or larger is used | |
| [Disabled] | or not. | |
Fast Command Porting | [Enabled] | Do not change the factory setting. | |
| Disabled |
|
|
|
| [ ]: |
|