IMPORTANT: If BrightStor ARCserve 2000 or Backup Exec is installed, the tape will not be recognized due to the failover of the PCI module. Thus be sure to stop the services before starting the PCI module.
1.Start [Services] from [Administrative Tools] of [Control Panel].
2.Select a service of backup software.
3.Choose “Stop” from the “Action” menu.
4.Repeat 2 and 3 for all services of the backup software.
The PCI modules’ status LEDs changes as shown below:
[Indications of the status LEDs]
Immediately after the PCI module startup until the completion of diagnosis
| LED | Secondary | Primary |
1 | BMC status LED | - | Green |
2 | PCI module status LED1 | Red | - |
3 | PCI module status LED2 | Green | Amber |
4 | DISK ACCESS LED | - | Amber |
DISK LED | Green | Amber | |
When duplication of disks is started after the completion of PCI module diagnosis * The status of LEDs varies depending on the method of disk duplication.
| LED | Secondary |
| Primary | |
|
| RDR | |||
|
| model |
| model |
|
1 | BMC status LED | - |
| - | Green |
2 | PCI module status LED1 | - |
| - | - |
3 | PCI module status LED2 | Amber |
| Green | Amber |
4 | DISK ACCESS LED | Amber |
| Green | Amber |
DISK LED | Amber |
| Green | Amber | |
After the completion of disk duplication and when the PCI modules are duplicated
| LED | Secondary | Primary |
1 | BMC status LED | - | Green |
2 | PCI module status LED1 | - | - |
3 | PCI module status LED2 | Green | Green |
4 | DISK ACCESS LED | Green or off | Green or off |
DISK LED | Green | Green | |