NEC NDA-24300 manual Sender Test Procedure, SRV=SSC, SID=17

SYSTEM OPERATIONS

(b) Sender Test Procedure

Lift handset

		(DT)
Dial access code for				•	Access code is assigned by ASPA command, CI=N,
designated connection
					SRV=SSC, SID=17
	“9xx”	+ “xxx”		•	Route number to be designated is as follows:
	RT No.		TRK No.

		RT NUMBER	TRUNK NAME
		905	Sender Trunk DP/PB
(Music On Hold)	Connection test is automatically
	performed Note 1
(SST)	•	If any of the dialed numbers are received correctly, a Reorder
		Tone (ROT) is heard.
Is next	NO
register to be		Hang Up
tested, too?
YES
	TRUNK DESIGNATION		TEST IN PROGRESS
			MUSIC ON
Make switch hook flash			HOLD
			ORT
Note 2
		ORT	SND
			DP
			OR PB

Note 1: After the sender to be tested is connected to the register, the sender sends out 1 ~ 9, 0 by DP signals and 1 ~ 9, 0, *, # by PB signals, thus checking to see if the dialed numbers are sent out correctly.

Note 2: If the trunk number of the next sender is not assigned, the test ends.

Figure 6-30 Sender Test Procedure/Connection Diagram

NDA-24300CHAPTER 6

Page 441

Issue 1