NEC NDA-24300 manual Data Output Details on DTFD/DTFDN Command, Full Command Name

SYSTEM OPERATIONS

(2)Data Output - Details on DTFD/DTFDN Command

To obtain the collected Traffic data, you can use the “DTFxxx” or “DTFxxxN” command as shown below. The commands can be activated by your direct log-in operation onto the MAT, but in normal cases, the com- mands are to be activated automatically at predetermined intervals assigned by the ATRF/ATRFN command.

Also, each command below corresponds to the Traffic Measurement “TYPE” assigned by the ATRF/ATR- FN command.

When performing traffic measurement on a node basis:

	Measurement “TYPE”	Command		Full Command Name
	(by ATRF Command)	Name
1	Terminal Traffic	DTF101		Display of Terminal Traffic Data
2	Route Traffic	DTF102		Display of Route Traffic Data
3	Station Peg Count	DTF103		Display of Station Peg Count Data
4	ATTCON Peg Count	DTF104		Display of Attendant Peg Count Data
5	Route Peg Count	DTF105		Display of Route Peg Count Data
6	Service Peg Count	DTF201		Display of Service Peg Count Data
8	UCD Route Peg Count	DTF301		Display of UCD Route Peg Count Data
9	UCD Group Peg Count	DTF302		Display of UCD Group Peg Count Data
10	UCD Station Peg Count	DTF303		Display of UCD Station Peg Count Data
15	ATT Answer Peg Count	DTF501		Display of Attendant Answering Peg Count Data
18	Connection Route Peg Count	DTF601		Display of Connection Route Peg Count Data
19	Connection Route Traffic	DTF602		Display of Connection Route Traffic Data
	When performing traffic measurement on a network basis (via TCP/IP):
	Measurement “TYPE”	Command		Full Command Name
	(by ATRFN Command)	Name
1	Terminal Traffic	DTF101N	Display of Terminal Traffic Data for Fusion Network
2	Route Traffic	DTF102N	Display of Route Traffic Data for Fusion Network
3	Station Peg Count	DTF103N	Display of Station Peg Count Data for Fusion Network
4	ATTCON Peg Count	DTF104N	Display of Attendant Peg Count Data for Fusion Network
5	Route Peg Count	DTF105N	Display of Route Peg Count Data for Fusion Network
6	Service Peg Count	DTF201N	Display of Service Peg Count Data for Fusion Network
8	UCD Route Peg Count	DTF301N	Display of UCD Route Peg Count Data for Fusion Network
9	UCD Group Peg Count	DTF302N	Display of UCD Group Peg Count Data for Fusion Network
10	UCD Station Peg Count	DTF303N	Display of UCD Station Peg Count Data for Fusion Network
15	ATT Answer Peg Count	DTF501N	Display of Attendant Answering Peg Count Data for Fusion Network
18	Connection Route Peg Count	DTF601N	Display of Connection Route Peg Count Data for Fusion Network
19	Connection Route Traffic	DTF602N	Display of Connection Route Traffic Data for Fusion Network

Note: For information on the command display images, see Figure 6-22, Figure 6-23, and Figure 6-24.

NDA-24300CHAPTER 6

Page 429

Issue 1