NEC NDA-24300 manual Set Sense switch at 2 DM Load Restart on the DSP of active, Cpu

SYSTEM OPERATIONS

Table 6-20 Start-Up When Basic & Application Software Is

Installed [Procedure #1] (Continued)

ACTION	7SEG LED/OPE LAMP/KEY
	SETTINGS

	A
Set SENSE switch at “2” (DM Load Restart) on the DSP of active			ATTENTION
	CPU.
			Contents
			Static Sensitive
			Handling
			Precautions Required
Enter your Office Data.
Back up Office Data using the MEM_HDD command.
Turn ON the EFFECT key on the TOPU. (See Figure 6-58)
Set the keys on the TOPU as follows.				SYSTEM DATA
			PROGRM
• PROGRAM KEY	→	NON LOAD
				NON LOAD
			LOAD
• SYSTEM DATA KEY	→	LOAD			LOAD
			NON LOAD
			PZ-DK222
Press INITIAL START button on the TOPU.
			CPU OPE and IMGX lamps on
			both DSP go OFF.
		• HD Initial	STATUS LED (right) on
			the DSP of CPU is ON.
		• DM Load	STATUS LED (right) on
		• System Initial	the DSP of CPU is ON.
			STATUS LED (right) on
		• System starts up again.	the DSP of CPU is ON.
			CPU OPE lamp on the
			DSP of active CPU
			lights steady-green. IMG0-3
			lamps flash.
			IMG0 lamp on the DSP of mate
			CPU flashes green.
			STATUS LED (right) on
	END		the DSP of CPU is ON.
			(ON LINE)

NDA-24300CHAPTER 6

Page 491

Issue 1