NEC NDA-24300 manual Functional Outline

ATRFN: Assignment of Traffic Measurement Order for Fusion Network

ATRFN: Assignment of Traffic Measurement Order for Fusion Network

1.Functional Outline

This command is used to assign and delete traffic measurement programs available on the Ethernet. A request for traffic measurement is performed on a network basis when a traffic measurement instruction has been assigned by this command. The collected traffic measurement data can be stored on the HD of the MAT (connected to the NCN: Network Control Node), which can be designated on the basis of traffic measurement type. Note that this command can be used at the NCN only.

2.Parameters

Input Data
	TYPE:		Type of Traffic Measurement (1-19) (See Table 8-3)
			Table 8-3 Type of Traffic Measurement Explanation
DATA			MEANING	DATA	MEANING
1		Terminal Traffic		2	Route Traffic
3		Station Peg Count		4	ATT Peg Count
5		Route Peg Count		6	Service Peg Count
8		UCD Route Peg Count		9	UCD Group Peg Count
10		UCD Station Peg Count		15	ATT Answering Peg Count
18		Connection Route Peg Count		19	Connection Route Traffic

PORT:	Traffic Information Output Terminal Number (0-7: IOC, 8: LAN, 9:NMS)
INTERVAL:	Output interval (0, 30-120)
	Assign the data (30-120) in 10 minute increments. When assigning 0 (available
	when any of TYPE 3-18 is selected), instead specify your desired output time in
	the “OUTPUT HOUR/MINUTE” parameters below.
START HOUR	Note 2, Note 3
START MINUTE	Note 2, Note 3
END HOUR	Note 2, Note 3
END MINUTE	Note 2, Note 3
OUTPUT HOUR:	This data is valid only when INTERVAL=0.
OUTPUT MINUTE:	This data is valid only when INTERVAL=0.
START RT:	Start External Route Number (available when TYPE 2/5/8 is selected)
END RT:	End External Route Number (available when TYPE 2/5/8 is selected)
START C_RT:	Start Connection Route Number (available when TYPE 18/19 is selected)
END C_RT:	End Connection Route Number (available when TYPE 18/19 is selected)

Note 1: The selected traffic measurement data, except for TYPE 1 (Terminal Traffic), is collected with the whole network systems as a single unit.

Note 2: When time difference exists between the nodes, confirm that the related time difference data, based on the UCT (Universal Coordinated Time) standard, has been assigned at each node via the ATDF command.

Note 3: Assign the traffic measurement time period between START HOUR/MINUTE and END HOUR/ MINUTE longer than an hour. Also, if the measurement should be executed throughout a day, assign the same data in both START HOUR/MINUTE and END HOUR/MINUTE parameters.

Note 4: If the data for this command is once assigned, the node-level data by the ATRF command is not cleared, but loses its validity (the network-level data takes precedence).

NDA-24300CHAPTER 8

Page 525

Issue 1