NEC NWA-008869-001 manual Switch Name, Setting, Function, Check, Number, Position

CHAPTER 2 INSTALLATION

INSTALLATION PROCEDURE

Switch Settings

SWITCH NAME			SWITCH	SETTING	FUNCTION	CHECK
			NUMBER	POSITION
SW					Source clock signal from network is
(Piano Key SW)			1	ON	sent to the PLO0 input on MP card
	ON				(2.0 MHz clock).
			NOTE 1
					Source clock signal from network is not
		1	NOTE 2
		2		OFF	sent to the PLO0 input on MP card
		3			(2.0 MHz clock).
		4
					Source clock signal from network is
			2	ON	sent to the PLO1 input on MP card
					(2.0 MHz clock).
			NOTE 1
					Source clock signal from network is not
			NOTE 2
				OFF	sent to the PLO1 input on MP card
					(2.0 MHz clock).
			3	OFF	Not used
				ON	WAN port or E1 interface for PBX are
					available.
			4
				OFF	Only WAN port is available.

The figure in the SWITCH NAME column and the position of in the SETTING POSITION col- umn indicate the standard setting of the switch. When the switch is not set as shown by the figure and , the setting of the switch varies with the system concerned.

Continued on next page

– 40 –	NWA-008869-001 Rev.1.0
	atch2001.fm