WLAN specific configuration 179

Enable Multicast Support on the WLAN Security Switch 2270 to enable use of the PTT feature for Nortel Handsets.

With the following settings, you can use Multicast for some of the regular SVP server and PBX control traffic:

Switch > General: Ethernet Multicast Support = Enabled: (2.2)

Switch > General, Ports: click ports 1 edit on right hand side of the screen and configure Multicast Appliance Mode = Enabled.

Turn off Rogue AP Detection.

Turn off AutoRF unless you are running software from Cisco version 4.0.206.0 or later. If you are running version 4.0.206.0 or later, configure the following additional parameters for AutoRF:

Parameter

Setting

Importance

 

 

 

Noise Measurement

3600

Required

 

 

 

Load Measurement

3600

Required

 

 

 

Signal Measurement

3600

Required

 

 

 

Coverage Measurement

3600

Required

 

 

 

Verify that Idle timer is configured to 300 seconds.

Verify that the AP session timeout is at least 1800 seconds.

Nortel recommends that you configure the AP session timeout to 65534 seconds.

Verify the following setting:

2230 AP DTIM = 3

If there are multiple WLAN Security Switch 2270s installed, which are intended to participate in a single RF mobility group, the following criteria must be met:

The RF mobility group name must be same on all 2270s that belong to the RF mobility group.

The mobility group name is case sensitive.

Configure the virtual IP address for virtual interface to a nonroutable address (for example, a fictitious address such as 1.1.1.1). The virtual IP address must be same on all 2270s that belong to the RF mobility group.

Manually add each switch to the list of RF mobility group members for each switch.

This is not a dynamic configuration.

For example, you have three switches: A, B, and C.

Nortel Communication Server 1000

WLAN IP Telephony Installation and Commissioning

NN43001-504 01.02 Standard

Release 5.0 15 June 2007

Copyright © 2004-2007, Nortel Networks

Page 179
Image 179
Nortel Networks NN43001-504 manual Parameter Setting Importance