Connect to the WLAN IP Telephony Manager 2245 101
the entire WLAN IP Telephony Manager 2245 group fails. All active calls are lost and no future calls can be placed until the master WLAN IP Telephony Manager 2245 is replaced (either by installing a spare or by reconfiguring one of the slaves to be a master).
•Alternately, if one of the slave WLAN IP Telephony Manager 2245s fails, the group as a whole still functions, although some individual calls can be lost due to the reassigning of handsets throughout the group. One less WLAN IP Telephony Manager 2245 also means that the call capacity of that node is lost until the failed WLAN IP Telephony Manager 2245 is replaced.
A
Configuration tasks
The following are the tasks required to configure the WLAN IP Telephony Manager 2245:
1."Connect to the WLAN IP Telephony Manager 2245" (page 101).
2."Configure the network" (page 103).
3."Configure the WLAN IP Telephony Manager 2245" (page 106).
4."Change the password" (page 108).
In the initial configuration of the WLAN IP Telephony Manager 2245, the IP addresses and the maximum number of active calls per AP must be configured. Later, you can use Telnet to configure the IP address of the TFTP Server where the software files are located and the hostname.
Connect to the WLAN IP Telephony Manager 2245
The initial connection to the WLAN IP Telephony Manager 2245 must be made through a serial connection to establish the WLAN IP Telephony Manager 2245 IP address. After the IP address is established, connection to the WLAN IP Telephony Manager 2245 can be done through the network using Telnet.
Nortel recommends that you perform the complete initial configuration after the serial connection is made.
Serial port connection
Follow the steps in Procedure 5 "Connecting to the WLAN IP Telephony Manager 2245 through a serial port" (page 102) to connect to the WLAN IP Telephony Manager 2245 through a serial port.
Nortel Communication Server 1000
WLAN IP Telephony Installation and Commissioning
Release 5.0 15 June 2007
