216Appendix B Troubleshooting WLAN IP Telephony installations

Configure the handset:

Admin Menu > Diagnostics > Diagnostics mode on

Admin Menu > Diagnostics > Syslog mode > full

If a Syslog Server is not available, use a public domain Syslog—for more information, see the KIWI Syslog Daemon available from www.kiwisyslog.com.

Signaling Server log capture

Use the CLI to obtain a log capture from the Signaling Server (SS).

Procedure 29

Using the CLI to capture a Signaling Server log

Step Action

1Open a telnet session to the SS.

2Start a file capture of the telnet session.

3Use the level 2 pdt password for the system to enter pdt.

4Change to the directory where the logs are stored.

For more information, see the appropriate NTP for the system.

5Determine the date stamps of the log files that cover the time frame for the problem scenario:

ll

6For a log file, run the command: rdopen log000xx.rpt

The response from the SS is Reading log000xx.rpt.

7For the same log file, run the command: rdall

8Repeat Step 6 and Step 7 for each log file.

9End the telnet file capture.

10Zip the capture and send it to Nortel.

—End—

Nortel Communication Server 1000

WLAN IP Telephony Installation and Commissioning

NN43001-504 01.02 Standard

Release 5.0 15 June 2007

Copyright © 2004-2007, Nortel Networks

Page 216
Image 216
Nortel Networks NN43001-504 manual Signaling Server log capture, Procedure Using the CLI to capture a Signaling Server log