Panasonic 524X07801B manual Direct Line Appearances, Multi-CO MCO Appearances

Section 700 - Operation Chapter 5. Key Telephone Features

Considerations

•If several calls arrive at a DSS/BLF key, the calls are queued and ring on a first-in, first-out basis.

•If a BLF key has a second call while busy and off- hook signaling is enabled, the BLF key starts blinking. The call can be answered by pressing the BLF key or going on hook and then off hook.

Direct Line Appearances

CPC-96, CPC-288, and CPC-576 All Versions

Direct Line (DL) keys are used to originate and receive calls over specific trunk numbers (DL keys can be assigned to any trunk number).

The LED for a DL key will flash red on an incoming call even if the CO line is set to ring. If another extension answers the call, the LED on the telephone will light solid red.

Operation

Operation		Action
To originate a trunk call...	1.	Press an idle DL key.
	2.	The key blinks green as the call is made.
To place a call on Exclusive Trunk Hold (page 133)...	1.	Press the DL key.
To place a call on System Trunk Hold (page 133)...	1.	Press the HOLD key.
To transfer a call...	1.	Press the HOLD key.
	2.	Dial the destination extension.
	3.	Press the PROG key.

Hardware Requirements

•N/A

Related Programming

•FF4: Key Assignment

Considerations

•N/A

Multi-CO (MCO) Appearances

CPC-96, CPC-288, and CPC-576 All Versions

Description

You can make and receive CO line calls using a Multi-CO (MCO) key. Each extension can have up to 5 MCO keys.

An MCO key can be assigned to any of the pooled trunk groups. Pressing the MCO key is the same as dialing the MCO Access Code (usually 9, 81-84).

576-13-700 DBS 576 (USA), Revised 6/11/98 165