204 DBS 576 (USA), Revised 6/11/98 576-13-700
Chapter 6. DSLT Features Section 700 - Operation
This feature works with Station Message Detail Recording (SMDR). During a phone call, a station
user can silently enter an accounting or client billing code. The entered Code will display on the
phone’s LCD as it’s dialed, so the user can tell it’s being registered. Then later, the SMDR reports will
show the Code dialed for each call, and even sort the report by these Codes.
There are two different types of account codes you can use in the DBS 576:
Non-Verified Account Codes
Non-Verified Codes aren’t checked by the system for validity; the user can enter anything from 1-10
digits long. Individual phones can be programmed to accept forced Account Codes (the user must
enter a code for ever y call) or voluntary Account Codes (the user can enter a code, but doesn’t have
to, for each call).
Non-Verified Account Codes can be assigned to incoming and/or outgoing calls. For incoming calls,
the user can enter the Code anytime during the call. For outgoing calls, the user either enters the Code
before accessing an outside line (for forced Codes), or anytime during the call (for voluntary Codes).
Verified Account Codes
Verified Account Codes entered by phone users must match a 4-digit code that has been
preprogrammed into an Account Code Table. (It is possible to enter up to 10 digits for a Verified
Account Code; however, only the first 4 digits will be used to verify the code.) These codes can also
be either forced or voluntary. You can program these codes with their own Toll Restriction Service
(TRS) Class assignment so that, when entered, they will override the extension’s TRS Class. Thus,
Verified Account Code users can “float” from phone to phone, placing calls that would normally be
restricted on that phone.
Non-Verified Account Codes
Non-Verified Account codes are voluntary codes. (i.e., You do not have to enter an account code
before making a call.)
You can assign Non-Verified Account codes to both incoming and outgoing calls. To assign an
account code to an outgoing call, you enter the account code before making the call or during the call.
To assign an account code to an incoming call, you enter the account code during the call.
Operation
To enter an account code before making a call:
Action Result
1. Lift the handset or press the ON/OFF key. Intercom dial tone
2. Enter the Account Code feature code (default = 8#).
3. Enter the Account Code (up to 10 digits).
4. Press the # key.
5. Press a vacant CO key or enter a trunk access code.
6. Dial the phone number.