Panasonic 524X07801B manual Camp-on Call Waiting, To use Automatic Camp-on

Section 700 - Operation Chapter 5. Key Telephone Features

Related Programming

•FF1 0 01 0020 Caller ID Log Outgoing

•FF1 0 01 0021 Caller ID Log Control for Private or Out of Area

•FF8 1 10 Set Caller ID Logging Extensions

Considerations

•Caller ID is available ISDN PRI.

•Caller ID circuit card must be installed and enabled. (See “Caller ID” on page 28).

•Caller ID is typically 10 digits. If the local calling area requires 7-digit dialing, the call log outdialing will not operate properly.

Camp-on (Call Waiting)

CPC-96, CPC-288, and CPC-576 All Versions

Description

If you dial a busy extension, you can camp onto that extension and send a Call Waiting signal to the called party. The called party then needs only to replace the handset and pick it up again to be automatically connected to the new call. The called party can also press the HOLD key to place the first call on hold and then answer the waiting call.

The System provides two types of call waiting:

•Automatic Call Waiting: You do not need to enter a code to send the Call Waiting signal to the busy extension. You need only to remain on the line.

•Manual Call Waiting: You must enter a code to send a Call Waiting signal to the busy extension.

Operation

To use Automatic Camp-on:

	Action	Result
1.	Lift the handset or press the ON/OFF key.	Intercom dial tone
2.	Dial the extension number.	• Wait XXX displays (where XXX =
		extension number/name)
		• Called party hears alert tone from the
		speaker.
		• Calling party hears ringback tone
3.	Remain on the line until the called party answers.

576-13-700 DBS 576 (USA), Revised 6/11/98 141