Panasonic 524X07801B manual 240

Chapter 6. DSLT Features Section 700 - Operation

*Indicates that the digits that follow are either a feature access code or an extension number. (Not needed if your System is set for Intercom Level.) See Note below.

**Indicates that the digits that follow are for an outside number and the System should seize the next available trunk when dialing. (Not needed if your System is set for CO Level.) See Note below.

Note: The System has two levels - CO Level and Intercom Level. If set at CO Level (default), you must enter the code for Intercom Level when programming a feature access code or extension number for speed dialing. If the System is set at Intercom Level, you must enter the MCO Code when programming an outside number for speed dialing.

System Speed Dial

You can store frequently called numbers using the SSD feature. Either 80 or 800 SSD numbers can be programmed, depending on how the System is configured. In an 80 SSD-number system, the SSD numbers are stored in bins 00-79. In 800 SSD-number systems, the SSD numbers are stored in bins 000-799.

Operation

To assign SSD numbers:

	Action	Result
1.	Lift the handset or press the ON/OFF key.	Intercom dial tone
2.	Enter the Speed Dial Set/Clear code (default = 710).
3.	Enter the SSD bin number (00-79or 000-799).
4.	Dial the phone number.
5.	Press the HOLD key.
6.	Replace the handset or press the ON/OFF key.

To dial an SSD number by entering the speed dial bin number:

	Action	Result
1.	Lift the handset or press the ON/OFF key.	Intercom dial tone
2.	If necessary, access an outside line.	Outside dial tone
3.	Press the AUTO key.
	OR...
	Enter the Speed Dial Originate code (default = 80).
4.	Enter the SSD bin number (00-79or 000-799).
5.	Complete call and replace the handset or press the ON/OFF
	key.

240 DBS 576 (USA), Revised 6/11/98 576-13-700