38 DBS 576 (USA), Revised 6/11/98 576-13-700
Chapter 3. System Features Section 700 - Operation
Table 6. System Mode Impact on TRS, Ringing, Attendant, and Built-in Voice Process ing Unit
Manual Day/Night Mode
You can manually change the System mode to Day 1, Day 2, Night, Night 2, or Night 3 mode by
either entering the correct dial code or by pressing the appropriately programmed FF key.
When using manual mode, the System may be configured to either use MCO tenant Day/Night modes
or system-wide Day/Night mode.
Operation
To switch Day/Day 2/Night modes using Feature Access Codes:
SYSTEM
MODE TRS RING ATTENDANT
BUILT-IN
VOICE
PROCESSING
UNIT
Day 1 Day TRS Mode Day 1 Ring Pattern Day 1 Attend. Group Day 1 Message
Day 2 Day TRS Mode
(Same for Day 1 and
Day 2)
Day 2 Ring Pattern Day 2 Attend. Group
Handling Day 2 Message
Night Night TRS Mode
(Same for Night 1,
and 2)
Night Ring Pattern
(Same for Night 1,
and 2)
Night Attend. Group
(Same for Night 1,
and 2)
Night Message
Night 1 Night TRS Mode
(Same for Night 1,
and 2)
Night Ring Pattern
(Same for Night 1,
and 2)
Night Attend. Group
(Same for Night 1,
and 2)
Night 1 Message
Night 2 Night TRS Mode
(Same for Night 1,
and 2)
Night Ring Pattern
(Same for Night 1,
and 2)
Night Attend. Group
(Same for Night 1,
and 2)
Night 2 Message

Switch Mode Procedure Indication

Toggle Day and
Night Modes 1. Pre ss the ON/OFF key. Intercom dial tone
ON/OFF LED lights
2. Enter 760.
3. Press the ON/OFF key ON/OFF LED goes off
If changing to Night mode, Red LED lights
If changing to Day mode, Red LED goes off
Day 2 Mode 1. Press the ON/OFF key. Intercom dial tone
ON/OFF LED lights
2. Enter 761 for the Day 2 Feature
code.
3. Press the ON/OFF key ON/OFF LED goes off
Red LED goes off