Paradyne 6800 manual Device Health and Status dhs, Device Health and Status Input Form

Modem/DSU Commands

Device Health and Status (dhs)

Use the dhs command to obtain health and status reports from DATAPHONE II or COMSPHERE devices. The health and status (alerts) of the devices downstream from the selected device can also be reported.

For most commands, NMS enables you to specify the destination for the command's results and schedule its execution. If the last page of the input form cannot accommodate the Destination for results and Schedule execution fields, an additional page is provided. For a complete description of these fields, refer to Chapter 1, Introduction.

Access Level: Help Desk, Data Technician, Manager, System Administrator

Abbreviation: dhs

Restrictions: None

Routine:Yes

Schedule:Yes

Related Commands: None

Device Health and Status Input Form

The Device Health and Status input form enables you to specify the device(s) for which health and status (alerts) information is to be reported, and allows you to specify reporting for a single modem or for a subnetwork.

This input form contains the following fields:

Device(s) (Required field)

Enter the device(s) from which health and status reports will be obtained. One or more devices may be specified. Standard addressing format applies to input. For information on device addressing, refer to Appendix D of the COMSPHERE 6800 Series Network Management System User's/System Administrator's Guide.

Type (Required field)

Specify whether health and status should be obtained from only the devices specified or from the specified devices and their downstream devices.

NOTE

DATAPHONE II devices always return subnetwork health and status results.

Enter single to obtain health and status from only the device(s) specified.

Enter subnetwork to obtain health and status from both the specified device and its downstream device(s).

A pop-up menu is available listing valid selections.

6800-A2-GB31-20 January 1997 2-97