Paradyne 6800 manual Display Call Directory dscd, Display Call Directory Input Form

COMSPHERE 6800 Series Network Management System

Display Call Directory (dscd)

Use the dscd command to display the telephone numbers stored in the call directory of a COMSPHERE 3800 Series modem, a COMSPHERE 3400/4400 Series modem equipped with a DBM, or a COMSPHERE 3600 Series DBM. To change the telephone numbers, refer to the Change Call Directory (chcd) command.

The 3600 Series DSUs contain 10 entries, one per telephone number. The DBM-V option has only 4 entries. For 3400/4400 Series modems, the telephone numbers are used by the Dial (dial) and Standby Facility (sf) commands to place calls and initiate backup.

For most commands, NMS enables you to specify the destination for the command's results and schedule its execution. If the last page of the input form cannot accommodate the Destination for results and Schedule execution fields, an additional page is provided. For a complete description of these fields, refer to Chapter 1, Introduction.

Access Level: Help Desk, Data Technician, Manager, System Administrator

Abbreviation: dscd

Restrictions: None

Routine:Yes

Schedule:Yes

Related Commands: Change Call Directory (chcd)

Clear Call Directory (clcd)

Dialing (dial)

Change Telephone Numbers (chtn)

Display Telephone Numbers (dstn)

Display Call Directory Input Form

This input form contains the following fields:

Device (Required field)

Enter the device for which the telephone number is to be displayed. Standard addressing format applies to the input. For information on device addressing, refer to Appendix D of the COMSPHERE 6800 Series Network Management System User's/System Administrator's Guide.

Directory number (Required field)

Specify the directory whose number should be displayed.

For COMSPHERE 3400/4400 Series modems equipped with a DBM, valid entries are from 1 through 4.

For COMSPHERE 3600 Series DSUs and 3800 Series modems, valid entries are from 1 through 10.

2-122 January 1997 6800-A2-GB31-20