Modem/DSU Commands

Receive Signal Spectrum (rss)

(Disruptive)

Use the rss command to measure the inbound received signal levels at various frequencies for a COMSPHERE 3400/4400 Series modem. The control modem, tributary modem, and primary data channel are affected when this test is run. This test will continue to run until the command is executed again using the abort option, or until an Abort command (abort) is executed.

For most commands, NMS enables you to specify the destination for the command's results and schedule its execution. If the last page of the input form cannot accommodate the Destination for results and Schedule execution fields, an additional page is provided. For a complete description of these fields, refer to Chapter 1, Introduction.

Access Level:

Data Technician, Manager, System Administrator

Abbreviation:

rss

Restrictions:

The tributary modem that is selected must be directly connected to the

 

specified control modem.

Routine:

Yes

Schedule:

Yes

Related Commands:

Abort (abort)

Receive Signal Spectrum Input Form

This input form contains the following fields:

Control Device (Required field)

Enter the control device to be involved in this test. Standard addressing format applies to the input. For information on device addressing, refer to Appendix D of the COMSPHERE 6800 Series Network Management System User's/System Administrator's Guide.

Mode (Required field)

Enter one of the following test options:

start

Starts the receive signal spectrum test at the selected tributary modem.

abort

Stops the receive signal spectrum test.

display

Displays the receive signal spectrum test results while the test is in progress.

A pop-up menu is available listing valid selections.

6800-A2-GB31-20

January 1997

2-189

Page 212
Image 212
Paradyne 6800 Receive Signal Spectrum rss, Receive Signal Spectrum Input Form, Control Device Required field, Display