COMSPHERE 6800 Series Network Management System

Disable/Enable (de)

(Disruptive)

Use the de command to enable or disable the transmitter on COMSPHERE or DATAPHONE II APL modems and COMSPHERE or DATAPHONE II DSUs.

For most commands, NMS enables you to specify the destination for the command's results and schedule its execution. If the last page of the input form cannot accommodate the Destination for results and Schedule execution fields, an additional page is provided. For a complete description of these fields, refer to Chapter 1, Introduction.

Access Level: Data Technician, Manager, System Administrator

Abbreviation: de

Alternate: dsab

Restrictions: When a device is disabled, primary data is affected; but the secondary diagnostic channel operates and the device responds to polls from the NMS. (This is not applicable to a COMSPHERE 3600 Series device.)

Routine:Yes

Schedule:Yes

Related Commands: None

Disable/Enable Input Form

This input form contains the following fields:

Device(s) (Required field)

Enter the device(s) to be disabled/enabled. One or more devices may be specified. Standard addressing format applies to the input. For information on device addressing, refer to Appendix D of the COMSPHERE 6800 Series Network Management System User's/System User's/System Administrator's Guide.

Device state (Required field)

Enter the desired device state. Valid entries are disable and enable.

A pop-up menu is available listing valid selections.

2-116

January 1997

6800-A2-GB31-20

Page 139
Image 139
Paradyne 6800 manual Disable/Enable de, Disable/Enable Input Form, Abbreviation de, Device state Required field