Modem/DSU Commands

Display Canned Message (dscm)

Use the dscm command to display the six stored messages in a COMSPHERE 3400/4400 Series APL modem. The canned messages are up to 40 characters long and can be sent to an upstream or downstream device, or to the NMS from the front panel of a 3400/4400 Series APL modem.

NOTE

You can only transmit canned messages from the front panel of a COMSPHERE modem. Use the Send Message (snm) command to send a user-defined variable message from the NMS to a COMSPHERE modem.

For most commands, NMS enables you to specify the destination for the command's results and schedule its execution. If the last page of the input form cannot accommodate the Destination for results and Schedule execution fields, an additional page is provided. For a complete description of these fields, refer to Chapter 1, Introduction.

Access Level: Help Desk, Data Technician, Manager, System Administrator

Abbreviation: dscm

Restrictions: None

Routine:Yes

Schedule:Yes

Related Commands: Change Canned Message (chcm)

Send Message (snm)

Display Canned Message Input Form

This input form contains the following fields:

Device(s) (Required field)

Enter the device(s) whose canned messages are to be displayed. One or more devices may be specified. Standard addressing format applies to the input. For information on device addressing, refer to Appendix D of the COMSPHERE 6800 Series Network Management System User's/System Administrator's Guide.

Message number (Required field)

Enter the number of the message to be displayed. Valid entries are from 1 through 6. A pop-up menu is available listing valid selections.

Display Canned Message Results Form

The results form lists device information for each device specified, and displays the selected canned message associated with each device.

6800-A2-GB31-20

January 1997

2-125

Page 148
Image 148
Paradyne 6800 manual Display Canned Message dscm, Display Canned Message Input Form, Display Canned Message Results Form