Modem/DSU Commands

Send Message (snm)

Use the snm command to send messages (up to 40 characters) from the 6800 Series NMS to one or more COMSPHERE 3400/4400 Series modems. The message can be read at the modem's front panel using the modem's Read Message command.

For most commands, NMS enables you to specify the destination for the command's results and schedule its execution. If the last page of the input form cannot accommodate the Destination for results and Schedule execution fields, an additional page is provided. For a complete description of these fields, refer to Chapter 1, Introduction.

Access Level:

Help Desk, Data Technician, Manager, System Administrator

Abbreviation:

snm

 

Alternate: smsg

Restrictions:

None

Routine:

Yes

Schedule:

Yes

Related Commands: Change Canned Message (chcm)

Display Canned Message (dscm)

Send Message Input Form

This input form contains the following fields:

Device(s) (Required field)

Enter the device(s) to which the message will be sent. One or more devices may be specified. Standard addressing format applies to the input. For information on device addressing, refer to Appendix D of the COMSPHERE 6800 Series Network Management System User's/System Administrator's Guide.

Message (Required field)

Enter the text message (up to 40 alphanumerics) to be sent.

Send Message Results Form

This results form displays a separate results page for each device specified. Each page lists device information for the device and a text message indicating whether or not the command was successfully executed.

6800-A2-GB31-20

January 1997

2-195

Page 218
Image 218
Paradyne 6800 manual Send Message snm, Send Message Input Form, Send Message Results Form, Message Required field