Paradyne 6800 manual Change Device Poll List chpl, Change Device Poll List Input Form

COMSPHERE 6800 Series Network Management System

Change [Device] Poll List (chpl)

(Disruptive for DATAPHONE II APL Modems and DSUs, and 3600 Series DSUs When Adding Tributaries)

Use the chpl command to add or delete devices in the poll list of a COMSPHERE

3400/4400 Series modem, a COMSPHERE 3900 Series modem, a COMSPHERE 3600 Series DSU, a DATAPHONE II APL modem, DSU, or Shared Diagnostic Unit (SDU).

Polling is the process by which alarms from devices in the network are automatically reported to the NMS. Once a poll list is established for a device, the device monitors everything on its poll list for health and status.

The NMS polls devices on the control channel. Those devices then poll devices downstream, and so on through the extended diagnostic network. A device always reports the health and status of all devices on its poll list to the device that polls it. NMS is, therefore, able to obtain health and status for all diagnostic devices in the network by polling only devices on the control channel.

For most commands, NMS enables you to specify the destination for the command's results and schedule its execution. If the last page of the input form cannot accommodate the Destination for results and Schedule execution fields, an additional page is provided. For a complete description of these fields, refer to Chapter 1, Introduction.

Access Level:	Data Technician, Manager, System Administrator
Abbreviation:	Abbreviation: chpl
Restrictions:	This command is disruptive to DATAPHONE II APL modems and DSUs,
	but nondisruptive to SDUs and COMSPHERE APL modems. This
	command is disruptive to 3600 Series DSUs when adding tributaries, but is
	nondisruptive to these DSUs when deleting tributaries.
Routine:	Yes
Schedule:	Yes

Related Commands: Acquire [Device] Poll List (acpl)

Display [Device] Poll List (dspl)

Change [Device] Poll List Input Form

There are two pages of the Change [Device] Poll List input form.

Page 1

Page 1 enables you to specify the device(s) for which you want the poll list changed. This input form contains the following field:

Device(s) (Required field)

Enter the device(s) whose poll lists are to be changed. One or more devices may be specified. Standard addressing format applies to the input. For information on device addressing, refer to Appendix D of the COMSPHERE 6800 Series Network Management System User's/System Administrator's Guide.

2-60 January 1997 6800-A2-GB31-20