COMSPHERE 6800 Series Network Management System

Change Multiplexer (chm)

(Disruptive)

Use the chm command to change the speed of the DATAPHONE II 2096C and 2096T modems, and both the speed and multiplexer options of the DATAPHONE II 2096A, 2144A, and 2192A modems.

You can lower a modem's line speed to allow transmission over degraded facilities, and you can change a modem's multiplexer configuration to accommodate numerous users (at low speeds) during peak hours and point-to-point data transmission (at high speed) during off hours.

Options can be changed on an individual modem or on a group of modems. Options of a group of modems are changed by specifying a control channel, a network, or a circuit.

For most commands, NMS enables you to specify the destination for the command's results and schedule its execution. If the last page of the input form cannot accommodate the Destination for results and Schedule execution fields, an additional page is provided. For a complete description of these fields, refer to Chapter 1, Introduction.

Access Level:

Data Technician, Manager, System Administrator

Abbreviation:

chm

 

Alternate: chmx

Restrictions:

You can change the options for only one model type at a time.

Routine:

Yes

Schedule:

Yes

Related Commands: Change Port Options (chpo)

Change Port Speed(s) (chpsp)

Change Multiplexer Input Form

There are two pages for the Change Multiplexer input form.

Page 1

This input form contains the following fields:

Device(s) (Required field)

Enter the device(s) whose speed or multiplexer options are to be changed. One or more devices may be specified. Standard DATAPHONE II addressing format applies to the input. For information on device addressing, refer to Appendix D of the COMSPHERE 6800 Series Network Management System User's/System Administrator's Guide.

2-56

January 1997

6800-A2-GB31-20

Page 79
Image 79
Paradyne 6800 manual Change Multiplexer chm, Change Multiplexer Input Form