Modem/DSU Commands

Display Alert Information (dsai)

Use the dsai command to display the message describing the reason for a facility (FA) or modem (MD) alert on a DATAPHONE II 2700 Series DSU.

For most commands, NMS enables you to specify the destination for the command's results and schedule its execution. If the last page of the input form cannot accommodate the Destination for results and Schedule execution fields, an additional page is provided. For a complete description of these fields, refer to Chapter 1, Introduction.

Access Level: Help Desk, Data Technician, Manager, System Administrator

Abbreviation: dsai

Alternate: dsfi

Restrictions: None

Routine:Yes

Schedule:Yes

Related Commands: None

Display Alert Information Input Form

This input form contains the following field:

Device(s) (Required field)

Enter the device(s) for which the fault information messages should be displayed. One or more devices may be specified. Standard addressing format applies to the input. For information on device addressing, refer to Appendix D of the COMSPHERE 6800 Series Network Management System User's/System Administrator's Guide.

Display Alert Information Results Form

Figure 2-33 is a sample Display Alert Information results form. This results form contains both facility alerts and modem failures.

6800-A2-GB31-20

January 1997

2-119

Page 142
Image 142
Paradyne 6800 Display Alert Information dsai, Display Alert Information Input Form, Display Alert Information Results Form