COMSPHERE 6800 Series Network Management System

Change Options (cho)

(Disruptive)

Use the cho command to change the device options of a COMSPHERE or DATAPHONE II device.

For most commands, NMS enables you to specify the destination for the command's results and schedule its execution. If the last page of the input form cannot accommodate the Destination for results and Schedule execution fields, an additional page is provided. For a complete description of these fields, refer to Chapter 1, Introduction.

Access Level:

Data Technician, Manager, System Administrator

Abbreviation:

cho

 

Alternate: chop

Restrictions:

None

 

Due to the interaction between the 3600 Series DSUs and the NMS, under

 

certain circumstances a cho command that is executed in a routine may fail.

 

In order to avoid this, it is recommended that the Display Options (dso)

 

command be executed before the cho command. This applies only to

 

3600 Series DSUs.

Routine:

Yes

Schedule:

Yes

 

Due to the interaction between the 3600 Series DSUs and the NMS, under

 

certain circumstances a scheduled cho command may fail. To avoid this, it

 

is recommended that the Display Options (dso) command be scheduled

 

before a cho command.

Related Commands: Change Multiplexer (chm)

Change Port Options (chpo)

Change Port Speed(s) (chpsp)

Display Options (dso)

Display Port Options (dspo)

Display Port Speed(s) (dspsp)

2-58

January 1997

6800-A2-GB31-20

Page 81
Image 81
Paradyne 6800 manual Change Options cho