Paradyne 6800 manual Call Test ct, Call Test Input Form, Number to dial Required field

COMSPHERE 6800 Series Network Management System

Call Test (ct)

Use the ct command to cause a COMSPHERE 3400/4400 Series modem with a DBM to initiate a call test using either the telephone number or directory entry specified. Once the proprietary tones are validated at the remote end, the test completes by disconnecting the dial line. Leased-line operation is not interrupted by this test.

For a 3900 Series modem, three different requests can be performed to initiate a call test. These tests are invoked by using a new field which appears on the input form when 3900 Series device addresses are specified in the device field.

For most commands, NMS enables you to specify the destination for the command's results and schedule its execution. If the last page of the input form cannot accommodate the Destination for results and Schedule execution fields, an additional page is provided. For a complete description of these fields, refer to Chapter 1, Introduction.

Access Level: Data Technician, Manager, System Administrator

Abbreviation: ct

Restrictions: None

Routine:Yes

Schedule:Yes

Related Commands: Standby Facility (sf)

Call Test Input Form

The Call Test input form contains the following fields:

Device(s) (Required field)

Enter the device(s) for which the call test is to be performed. Multiple devices can be specified. Standard addressing format applies to the input. For information on device addressing, refer to Appendix D of the COMSPHERE 6800 Series Network Management System User's/System Administrator's Guide.

Number to dial (Required field)

Enter the telephone number to be dialed, or a directory whose number should be used. See the Change Call Directory (chcd) command for a list of valid dialing characters for the 3400/4400 Series modem with a DBM. See the Dial (dial) command for valid entry formats.

2-32 January 1997 6800-A2-GB31-20