COMSPHERE 6800 Series Network Management System

Change Thresholds (cht)

Use the cht command to set thresholds on COMSPHERE 3400/4000 Series modems that will determine when alerts should be generated. Threshold (TH) alerts will be generated when the line parameters exceed the thresholds defined by this command.

For most commands, NMS enables you to specify the destination for the command's results and schedule its execution. If the last page of the input form cannot accommodate the Destination for results and Schedule execution fields, an additional page is provided. For a complete description of these fields, refer to Chapter 1, Introduction.

Access Level: Data Technician, Manager, System Administrator

Abbreviation: cht

Restrictions: None

Routine:Yes

Schedule:Yes

Related Commands: Display Thresholds (dst)

Circuit Quality (cq)

Change Thresholds Input Forms

There are two pages for the Change Thresholds input form.

Page 1

Page 1 enables you to specify the device(s) for which you want to change threshold values. This input form contains the following field:

Device(s) (Required field)

Enter the device(s) for which thresholds are to be changed. One or more devices may be specified. Standard addressing format applies to the input. For information on device addressing, refer to Appendix D of the COMSPHERE 6800 Series Network Management System User's/System Administrator's Guide.

Page 2

Page 2 enables you to change the threshold parameters as applicable for the device specified. Figure 2-17 is a sample of Page 2 of the Change Thresholds input form.

2-74

January 1997

6800-A2-GB31-20

Page 97
Image 97
Paradyne 6800 manual Change Thresholds cht, Change Thresholds Input Forms